IMG_2648.jpg (54.9 KiB) Viewed 4359 times
For those of you who have been spending your evenings on metal folding chairs, or cheap wooden collapsibles with foam so old and compressed that it might as well not be there, this may be of some interest.
Total project cost was about 50 bucks
Passenger seat (with motors) - $23
disgusting office chair off of the side of the road - free
plywood board and hardware- ~$25
And an afternoon
Eventually I may purchase some seat controls and mount them to the side, to get the tilt/slide feature. I don't think they're useful on a desk chair, but it would be funny.
